|
|||||||
|
|||||||
|
|||||||
| Prelude Discussion of all model Preludes.
![]() |
![]() |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
#1 (permalink) |
|
Junior Member
Join Date: Jun 2007
Posts: 2
|
My last motor threw a rod, so I replaced it with a junk yard motor. Car runs real good (for what it is) but has a bit of what sounds like valve clatter. The oil that was in it was extreamly clean. I gave it a full tune up.
Also......When in stop and go traffic, it tries to rev up to 2000 rpm with the clutch down, but I can pull the pedal up and it stays down till the next time I touch the accelerator. And... Sometimes after short trips and sitting for an hour, it refuses to start. I'm starting to hate this car.....Please help me if you can. Thanks |
|
|
|
|
|
#3 (permalink) |
|
Junior Member
Join Date: Jun 2007
Posts: 2
|
Thanks for the reply.
I'm used to old chevys so I had no idea that I could adjust the valves on this thing. I'll lube the cable and see also....Yesterday in traffic it started to rev up and down on its own. I think I bought a possesed piece of crap. Thanks again! |
|
|
|
|
|
#4 (permalink) |
|
Junior Member
Join Date: Jan 2008
Posts: 1
|
Running up and down sounds like a vacuum leak, check all your lines. Could also be a sticking idle control valve.
I also think I remember something with these older preludes about some coolant leaking into the throttle body and gumming it up. I think there was a recall or something, but just clean out the throttle body good and see if that helps. I remember that hot engine refuses to start problem, too. I think it had something to do with the cold start injector or something simple. Wish hondaprelude.com was still around, all this stuff was posted on there! I'll try to remember... |
|
|
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|